View Work Exempt From Building Permits (4551) to determine if a permit is required.

Work exempt from a building permit must still comply with applicable local and State building regulations and codes. Furthermore, the Chula Vista Zoning Ordinance applies to the use and location of all structures, including those not requiring a building permit. All new structures must therefore be reviewed by the Planning Division to ensure the structure meets the requirements of the zone. Please check with Planning staff to ensure your proposed structure meets all standards, such as setbacks from property lines and adjacent structures, allowable height, and lot coverage.

Any required discretionary approvals (Design Review, Conditional Use Permit, etc.) must be in place before applying for a building permit. Please check with staff at our Permit Counter or contact us with any questions prior to submittal.

Submit a complete application package, including:

1. Residential Addition/Remodel Application (4562A)
2. Plot/Site Plan showing general layout of the building site, location of new and existing buildings, retaining walls, and other structures.
3. Construction plans and details, including, but not limited to:
   1. Title sheet
   2. Foundation plan
   3. Floor plan
   4. Elevations
   5. Roof plan
   6. Cross sections
   7. Framing plans
   8. Details and other applicable plans, as listed in the Residential Addition/Remodel Application (4562A)
4. Other Documents
   1. Soils Report or completed Soils Report Waiver (4597)
   2. Title 24 energy compliance documentation (Certificate of Compliance sheets shall be reproduced on actual plan sheets)
   3. Structural analysis/calculations
   4. Engineered trusses layout and details (if roof/floor trusses are used)
   5. Single line diagram for electrical services over 200 amps

Please see our Project Submittal Page for current application procedures.

Once the building permit is issued, you can start construction. At certain stages of construction, you must schedule an inspection. The following represents the sequence of required inspections for a typical residential addition:

• Underground plumbing and electrical
• Foundation
• Roof nailing
• Exterior wall construction
• Interior framing and rough trades (electrical, plumbing, mechanical)
• Drywall nailing
• Lath nailing
• Gas pressure test
• Final Inspection

Schedule an Inspection 

For a list of detailed information on what is to be completed for each inspection see our Single-Family Dwelling and Room Addition Inspection Information.

After all required inspections are approved and required approvals from other divisions are obtained, our Building Inspector will sign-off the Inspection Card.

• Residential Plot Plan Guide (4595)
• Fee Information

At permit application, you will be required to pay Building Permit fees (Intake & Plan Check fees). At permit issuance, you will be required to pay Building Inspection fees. Both fees are based on occupancy type, construction type, and square footage.